Batch 3 -
See details underneath the loader.
I'm still thinking if I should cut that Independence Air A319, which I happen to purchase from waffle, you know JB, This little bus is an a-ss-sitter. I bet you never checked that item before you even put it up on the your sell/trade-list ?
Guess this one will have to be butchered and sacrificed and to be eaten by the beluga.
Thank to my fellow collector here from DAC that donated me these 6-7x Belugas for my future toulouse diorama. I knew I could use them for something good. so thank you. You know who you are. (name withheld as requested by the donor)
Photo 1
As you can see here, the wings are resting on a single square sold block, but I might change that into 2 blocks instead to distribute the weight better.
Photo 2
This one was put on its side to show you what I did down underneath. There's crossing beams all over it, There are two units for the wheels at both ends, so easy to assemble, but the plastic rod in the middle which will be painted as the hydraulic rod. That one was a b1tch to deal with, I had to sit there with a pincet and it was a little hard due to the tight gap.
Photo 3
I wrapped the wings into with tape.
Any comments and suggestions are more than welcome. Thanks. Have a good day !